5 Most Common Problem with Window AC

To start off let us discuss the root cause of the Air conditioning problem first. No matter if it’s a split or window, lack of servicing and seasoned cleaning schedules is what hinders the health of an AC. A well-maintained AC will run less on electricity and require fewer repair sessions. So, make sure you get your AC checked at the beginning of every season and a cleaning session after the season is over.

So, let’s get back to the topic and here are 5 most common problems with window AC:

1. Dripping water from the AC front

One of the most pressing issues is this drippling problem. Though it is nothing but a minor installation fault, it could be disastrous for old window ACs. To avoid, you need to ensure that your window AC is slightly tilted towards the rear back end, where the water drainage pipe is located. This will help flush out the excess water easier.

2. The frequent on and off cycles by the compressor

There are 2 potential reasons for the problems, either your temperature sensor is not working or your thermostat has given up. Check if your temperature sensor sits on its stand near to the evaporator coils. Then see your AC filter is not clogged with dirt. If it is then clean it with a washing liquid. Check your AC if the problem still exists, then your problem is with the thermostat and you need a professional to repair it.

3. AC Icing

Ice forms when the level of refrigerant decreases than the required level. This makes the temperature in the cooling coil to drop even more. These phenomena result in the room moisture to condense and deposit on the cooling coil. This is a problem you cannot fix on your own. You need to call an expert to determine if your refrigerant level is right or not.

4. A non-starting AC

In this problem, the PCB is the part to blame. There is no standard explanation for why a PCB stops functioning. It can be due to recurrent on and offs or a physical damage endured during the installation session. In some cases, the IC or capacitor are burnt, in which case, their replacement is cheap and easy. But an entire PCB repair or repayment requires a lot of money.

5. Frequent on and offs by the compressor

The issue arises when the temperature inside the AC spikes higher than usual, in which the temperature sensor cuts the power supply to the compressor to cool down. This might happen due to breaks in the power supply or less space outside of the AC to breath out the hot air. Window AC Dealer in Delhi might help you in this situation. He will either relocate your system or change the electric cables.